Bankdruk techniek

[inferno_0666]

Links: slechte techniek, de pols buigt naar achteren. Rechts: correcte techniek, de pols en de onderarm zitten op een rechte lijn.




Links: slechte techniek, de stang is te ver verwijders van de pols richting de vingers. Rechts: correcte techniek, de stang zit dicht bij de pols.

[BSH1975]

muchos gracias

nah, vanavond maar eens proberen als ik thuis ben van werk.
Op die kleine dingen heb ik nooit echt gelet.

Thanks

[inferno_0666]

How To Increase Your Bench Press With Proper Technique

Onderstaand artikel hoort bij het eerste filmpje.

=========================================


How To Increase Your Bench Press With Proper Technique
Lee Hayward - July 03, 2008

The Barbell Bench Press is one of the most popular gym exercises. It is also one of the most misused exercises. Part of the problem is that the bench press is an ego exercise. A lot of guys judge their training progress based on how much they can bench. So often times they end up training too heavy and using poor technique in effort to lift more weight.

The average gym member will usually try to increase their bench press by doing more reps, sets, or weight on bench press. When in reality they will gain more strength and make better progress over the long term if they focused their effort on improving their bench press lifting technique rather then simply lifting more.

The best way to make big strength gains in your bench press in the shortest period of time is to improve your form. The techniques listed below are used by the best bench pressers in the world. But keep in mind that changing your bench press technique can take a bit of getting used to and initially your poundages may go down before you get the hang of the new technique.

This is just like when you first learnt how to use a computer and started off as a two-finger typist. You can type with two fingers, but not very fast. Then when someone eventually taught you the proper way to type, using all fingers, you probably found it very frustrating at first. Most likely you couldn’t even type as fast as you could with just two fingers. But with a bit of practice you eventually got to the point where you can click away on the keyboard faster using the proper typing technique compared to the old two finger method. The same will hold true for your bench press, once you get used to the proper lifting technique your strength gains will progress much faster.


Proper Bench Press Technique

Many people do not realize how much strength they lose by making the bar travel further than necessary. The less distance you have to move the weight the stronger you will be. To shorten the distance that you press the bar you need to expand your rib cage and stick your chest out. While at the same time squeezing your shoulder blades back together behind you.

You can even try this now while sitting hear reading this. Right now sit up tall in your chair and take a deep breath, expand your rib cage, and stick your chest out as far as you can. At the same time squeeze your shoulder blades back as far as you can. Now do it again, but this time hold your arms out in front of you as if you were doing a bench press. You can even alternate holding your arms out in front with your upper body relaxed and then holding your arms out in front with your chest out and shoulders back.

There will be at least a few inches of distance in the difference. By expanding your chest you can shave an inch or two off your bench press stroke. And by pulling you shoulder blades back together you’ll reduce the distance by another inch or two. Look at the picture below and you’ll see the difference. See how far the elbows are in front of the torso in the first pic compared to the second pic. Yet, the arms are straight and locked out in both pictures.



In addition to proper upper body positioning, you also need to drive through your legs to be a good bench presser. When you set up on the bench your feet should be firmly planted on the floor and you should push with your legs as if you were trying to slide your back up the bench, without actually letting your back slide up the bench. A lot of powerlifters will put lifting chalk along their upper back to help create more friction on the bench and allow them to drive with their legs without sliding up the bench. This will help stabilize and support the entire body and also help you hold the “chest out and shoulders back” position even better.

When you position yourself on the bench press, set up so that your eyes are in direct line with the bar. This is the ideal place to take the bar out of the rack and maintain your proper body position as outlined above.

To handle maximum weights you need to keep your entire body tight. Once you are set up on the bench, grasp the barbell and squeeze it hard and try to pull outwards while keeping that tight grip on the bar. This will instantly tense and activate the muscles in the upper back and create a more solid base.

Once you un-rack the bar hold it at arms length for a couple seconds and let the weights settle. Focus on keeping your proper set up by sticking your chest out, pulling your shoulders back, and driving with your feet. Then take a deep breath and hold your air. By holding your air you’ll stabilize your torso and keep more tension in your body. (Note: you can breath in and out normally in between reps, but during the actual lift itself hold your air in).

Lower the bar somewhere between your nipples and where your chest and upper abdominals meet. The actual spot where you touch the bar may vary from person to person, and depends on your individual body structure.

As you lower the bar keep your elbows tucked in so that your upper arms are at a 45 degree angle with the sides of your torso. By keeping your elbows tucked in like this, and not letting them flare straight out to the sides you’ll keep more strength in the bottom of the lift and place less stress on your shoulder joints.

When you lift the bar back up the chest muscles will start the initial drive off the body, but once you get half way up the triceps will take over and finish the lift. To help activate the triceps more and lockout the lift, visualize straightening your arms out underneath the bar. Rather then trying to keep pressing the bar up. Another way to think of it is to visualize shoving yourself away from the bar, rather then pressing the bar.

To show you what I mean, stand up against a wall and assume a push up position. Lean in and push hard against the wall, almost like you are trying to push a stuck car. In this position you are pushing hard, but your elbows are still bent. Try it again, but this time stand up against the wall, and instead of pushing hard against the wall, just focus on straightening your arms out and shove yourself away from the wall.

This is what you should do when you get to the half way point of the rep, rather then just pushing against the bar, focus on straightening out your arms underneath the bar and shoving yourself away. This change in focus can really help you finish off the lift when you hit the sticky point half way up.

Implementing these technique tips into your bench press workouts will take a bit of practice, but once you get good at them the results are amazing. You’ll feel solid and strong during your lifts and most importantly you’ll be able to lift more weight, with better form, and less risk injury as you will not be placing excess stress on the shoulder joints.

[Teddek]

Inweze ga je dus decline drukken op een flat bench...

[Revius]

Inweze ga je dus decline drukken op een flat bench...

En daar is wat mis mee?

[Teddek]

En daar is wat mis mee?

Zie je mijn constatering als kritiek?

[Revius]

Zie je mijn constatering als kritiek?

Daar leek het op

[Iron Mind]

Mooi stukje. Misschien ga ik ooit nog eens de 100kg halen met al deze tips, haha.

Vooral die legdrive is belangrijk voor mezelf denk ik.

[adon1s]

Allemaal leuk en aardig, maar elke keer deze filmpjes wordt een beetje vermoeiend.
Het gaat in dit soort filmpjes ook nooit om de vraag hoe je meer massa bouwt in je pec's, maar alleen de techniek om meer te benchen wordt behandeld.

‪FAT LOSS & Bodybuilding Secrets: Get Big Chest Muscles & Pecs‬‏ - YouTube

Ik snap je punt, maar zet er dan niet zo'n onzin filmpje bij waarbij hij onderin compleet z'n spanning verliest (spanning verliezen bij welke oefening dan ook is blessuregevoeliger). Blijft 'tight'. Dat heeft niets met kracht/massa te maken, alles met bewustzijn van wat je doet..

[Teddek]

Daar leek het op

Ha, als dat zo was dan stond er zoiets als "ga dan decline benchen."
Ik probeer zelf ook zo te bankdrukken. Tijden geleden al een filmpje van Jeff Tate gezien en wist me wel te overtuigen.

[Revius]

Jeff Tate, is dat de maat van Layne Wendler en Louie Norton?

[Teddek]

Looool Dave natuurlijk

[BelowZero]

en ik word moe van je bodybuild gelul alsof dat de enige echte manier is.

Falstyr's 120 kg bench. - YouTube



Ben jij dit Falstyr?

Falstyr's 120 kg bench. - YouTube



Ben jij dit Falstyr?

jup dat is hem, met nog ene lid van BN

[BelowZero]

Ok,kwam dit filmpje tegen op muscleboard in een topic van MartinNoppert die is daar mod moest wel lachen Wou het Falstyr toch ff laten weten.

Bankdrukken PL of BB style ?